Anti-rust primer and topcoat in one, based on alkyd resins for direct application onto rust.

Long lifetime
Maximum elasticity
Low odour
Excellent anti-corrosion protection
Excellent one-coat cover
Resistant to knocks

Coverage:10.5m²/L

Drying Time:2 hours

Time Between Coats:8-16 hours

Use:INTERIOR & EXTERIOR

Application Method:ROLLER, BRUSH, SPRAY

Thinner:THINNER 7302 (COMBICOLOR)

RECOMMENDED USES
CombiColor Hammertone 7300 can be applied directly on bare, manually derusted or with
CombiPrimer Anti-Corrosion 3369/3380 primed steel.
CombiColor Hammertone 7300 is intended for brush and roller application and can also be
applied by air spray.
On properly primed or previously coated surfaces CombiColor Hammertone 7300 offers
corrosion protection in a light industrial environment.
For metal structures in a more aggressive industrial environment, application of an additional
CombiPrimer Anti-Corrosion 3369/3380 is recommended or a second coat of
CombiColor Hammertone 7300 can be applied.

Coverage
Theoretical: 8.0 - 8.5 m²/l, depending on colour.
Practical: Practical coverage depends on many factors such as porosity and
roughness of the substrate and material losses during application.

SURFACE PREPARATION
Remove oil, grease and all other contamination by alkaline or high pressure (steam) cleaning
in combination with appropriate detergents.
Remove rust scale, loose mill scale, loose rust and loose coatings by scraping and wire
brushing to St3 (ISO 8501-1: 1988), light blast cleaning or sanding, followed by priming with
the recommended CombiPrimer Anti-Corrosion 3369/3380.
Sand previous coatings in good condition to provide a key for adhesion and check
compatibility. The surface must be clean and dry during application.
Galvanised, Zinc and Aluminium surfaces have to be primed first with CombiPrimer Tack Coat
3302.

DIRECTION FOR USE
To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
APPLICATION & THINNING
Brush: Up to 10 vol. % with 7301.
Use natural bristles, long hair flat brushes for optimal hammertone
appearance.

Roller: Up to 10 vol. % with 7301.
Use short nap poly-amide (Perlon 6 - 12 mm) rollers.

Air-atomised spray: 10-25 vol.% Rust-Oleum Thinner 7302.
Gravity cup and pressure cup.
Tip size: 1.0 - 1.5 mm. Atomising pressure 2 - 4 bar.

Cleanup: Use Rust-Oleum Thinner 7301 or mineral spirits.

APPLICATION CONDITIONS
Temperature of air, substrate and coating material between 10 and 35°C, relative humidity
below 85%. The substrate temperature must be at least 3°C above dew point.

REMARKS
Brushes, rollers and cleaning solvents should only be used for hammertone application.

SAFETY
Consult Safety Data Sheet and Safety Information printed on the can.

SHELLIFE / STORAGE CONDITIONS
5 years from date of production in unopened cans, if stored in dry, well ventilated areas, not in
direct sunlight at temperatures between 5° and 35°C.